flashforge dreamer just not printing right

General discussion on 3D hardware from beginner to expert.
Post Reply
Posts: 3
Joined: Sun Jan 28, 2018 9:49 am

flashforge dreamer just not printing right

Post by terry1956 » Sat Apr 14, 2018 7:00 pm

hi, I purchased a new flashforge dreamer after a year of printing with an XYZ printer. apart from printing the test print, I have not been able to get the printer to print anything. I am using S3D and sending the work v USB. the printer starts printing but it is so poor that I just cancel.

what settings are you chaps using on this printer. much help needed.

User avatar
Posts: 154
Joined: Thu Jan 29, 2015 5:04 pm
Location: Stroud, UK
Been thanked: 4 times

Re: flashforge dreamer just not printing right

Post by iDig3Dprinting » Sun Apr 15, 2018 12:29 pm

When you say the printing is poor what exactly is poor about the print. How a print comes out can be used as a symptom of the problem. A picture of a print would be very handy.

Your source for 3D printers, 3D printing accessories and filament.

Posts: 10
Joined: Tue Mar 20, 2018 4:26 am

Re: flashforge dreamer just not printing right

Post by steve3dprinters » Thu Apr 26, 2018 9:52 am

Please describe your troubles in a bit detail and the areas in which are facing issues. Flashforge Dreamer is generally a good 3D printer which works exceptionally well under normal conditions.
The troubles could be relating the settings and if you describe the type of trouble faced, it would be easier to get the solution. Also, you can refer the user manual of the 3D printer for solutions.


Post Reply