Page 1 of 1

3d print with solid bottom help

Posted: Thu May 23, 2019 2:11 pm
by newenderuser
Hi,

I am new to 3d printing..i have an ender 3 and use fusion 360 to make my design and cura to do the slicing.

i am trying to print a solid disc 22mm diameter and 1.5 mm thick with a M6 thread attached.

The print is infilling the centre of the disc and i am wanting it to be solid..i have altered the values in cura like bottom thickness and bottom layers but i still cannot get it to be solid.

Any advice would be great.thanks

Image