Hello

General discussion on 3D hardware from beginner to expert.
Post Reply
Yamaha10
Posts: 1
Joined: Sat Jun 08, 2019 9:51 pm

Hello

Post by Yamaha10 » Sat Jun 08, 2019 10:03 pm

Hi all

Just like to say hello.

Planning to start to see if I can print some no longer available motorbike parts (Yamaha RD LC's to start with) at home

Lots of 3D modeling experience in SolidWorks (due to my job role as an automation / manufacturing engineer) So have now decided (rather than use the works printers for "foreigners") to start myself up at home, so bought myself a Ultimaker 2 that has been upgraded to a 2+

No doubt I will have 1001 questions, but hello for now.

Catch up soon.

Best wishes to all Al.



Post Reply